Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / krishan meghwanshi
1=ratio test
2=core balancing test
3=vector test
4=meger value
5=polorization index test
6=magnetic balancing test..
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the formuala to calculate the rating of motor protection circuit breaker
How is operate breaker failure scheme in substation
What do you mean by Stimulastion Test in Diesel Genarator / Why & when it's conducted ?
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
I have been using an 600VA with 0.6 p.f UPS with my desktop which has 450W power supply unit. Can anyone explain how can this happen . Because the output of the UPS is 360W (600*0.6) (<450W)
why three phase capacitor takes unbalanced current in capacitor bank?
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
If a high resistance fault occurs,then what are the changes will happen in the system?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
What is center gravity load in substation?
what is meant by twilight switches 7 where its applicable ?
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
what parameters are should nessary for control technic dc drive(in rolling mills)?
please send me previous year questions of jspl through which i could prepare myself for the test.
