Interested to Buy Any Domain ? << Click Here >> for more details...
what is dead weight tester and where it is used?.
- 11 Answers
- 21948 Views
- DuPont, Jain steels, I also Faced
- E-Mail Answers
Answer Posted / khustar9769797739
Dead weight tester used for pressure gauge, pressure
transmitter, pressure switch calibration in high range.
(Kgcm2or bar). it is used for industrial purpose in
instrumentation department
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is instrumentation control?
Why are the uses 24vdc in industries
How d.p. Transmitter can be applied to close tank?
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
why we are using drum level control valve air to close?
What is eddy current? Describe the operating principle of proximity probe.
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
Hook up resistance decade box to temp.transmitter.
How hart protocol can be connected with control valves?
Who to difference between analog in & analog out in dcs?
if in a level tx height is given, how u calculate the ranges of the tx?
how to commission furnace ( water heater)
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
