What is meant by Reactor in power system and what are the
uses?
Answer Posted / विशाल खरवा
Reactor is a very high inductive coil which has approx zero power losses and high reactance. Which generally used with EHV transmission lines.
Application–
1. Reactor is used to minimise the faulty current of transmission line.
2. Reactor is used to compensate the ferranti effect and capacitive effects.
3. Reactors used for connecting two lines. I.e. as a tie line connector.
4. Reactor opposes the change of faulty and dangerous current.👍👍
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
How to Make relay co ordination chart for a Electrical power distribution of a plant
what is the importance of earthing system on the generators big capacity and small?
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
Can anyone tell me some hints about what type of questions are asked by the interviewer by an Electronics engineer when company is installing an IPP and wants a team of engineers?
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
what is the ms flat constant for calculating earth mat design calculation?
What is the Difference between Ac Drives and Dc Drives? According to application, speed, Torque, cost, Reliability, Construction, Motor etc... Thankyou !!!
Which is the oldest hydropower plant in india?
1.what is difference in maintain Hz again Hz in USA ? 2.how to calculate the battery AH? 3.why are yearly maintained in transformer how many tests in required?
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?