Answer Posted / sathish

In earlier days, the ceiling fan is very heavy and down rod pipe is connected with fan through threaded coupling and chuck nuts. When the ceiling fan starts rotating in anti clock wise direction the armature winding part take jerk in clock wise direction. This clock wise movement helps to prevent the joint getting loosen. Hence the ceiling fan designed to rotate in anti clock wise direction.

What is pd controller?

645

---

Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.

1869

---

What is the difference between circuit breaker and isolator

720

---

In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.

1336

---

what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?

1099

---

---

HOW TO CALCULATE S/C,O/C,E/F OF ACB.

2144

---

i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.

1602

---

Why star delta starter is preferred with induction motor?

631

---

What is the need of generator relay panel

1521

---

How you calculate the repturing capacity of a HRC fuse

2102

---

send me any model test paper of clerical post of state bank of india.......

1381

---

Difference between Earthing Truck & Earthing trolly for HT panel

3811

---

In how we connect watt meter for open & short circuit test of a single phase transformer.

5640

---

what is the safety of voltage power transformer(2250KVA0

1550

---

How to calculate the no of Ceiling fan (1200mm sweep) per unit area?

1386

---