Answer Posted / pratik
When motor is overloaded for longer duration it's current Ia increases which cause heat in winding and as the heat increases the flux produced by the winding comes to saturation at one point,and so the motor stops to rotate.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the formula for calculating no-load current?
How many VSC based HVDC are there in India and the world
Why is a plain induction motor unsuitable for wide speed control?
Define unilateral circuit?
What happened ,If 3 phase clearance not maintained in 33KV Line,11KV LIne etc?
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
How wire size can define in electrical wiring? What is the ratio?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
How cable from Kit-Kat to main switch, from starter to motor are designed?
Differentiate between ideal and non-ideal voltage sources?
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
what is the use of expulsition protective gap in 11Kv line.
How does zener phenomenon differ from avalanche breakdown?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
What is warm / cold start of HT motors. How many warm start & cold start are possible in a day?
