Interested to Buy Any Domain ? << Click Here >> for more details...
What type of DC Generator is used for Arc Welding purposes?
- 7 Answers
- 39641 Views
- CPCL, Rubicon, I also Faced
- E-Mail Answers
Answer Posted / ankit tiwari
In welding process higher no load voltage is required to iniate the arc,after the arc is initiated lesser voltage is required to maintain the arc.it is only given by only differential compound generator.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Give two basic speed control scheme of dc shunt motor?
Why do power lines not short out when they fall into water?
Why is the frequency not changed during transformation of electrical energy in a transformer?
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor
How work of capacitor in dc supply...???
why r we using shell transformer for low voltage
From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
DG cranking voltage?
If we want to change a contactor of faulty one what are the conditions want to fullfil
list of tests to be carried out at manufacturers end while purchasing a step up transformer of 11kv to 66kv ,2MVa Capacity.
What is the use of lag compensator?
When lag/lead/lag-lead compensation is employed?
WHY L-G FAULT IS MORE SEVERE IN TERMS OF RRRV?
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
How to calulate Locked rotor amper(LRA) for compressor type motors?
