Interested to Buy Any Domain ? << Click Here >> for more details...
How do you measure g's?
- 5 Answers
- 21268 Views
- Aramco, GNFC, HPCL, Polmon, Thermax, I also Faced
- E-Mail Answers
Answer Posted / valluri066
G's or G-force can be easily measured using Accelerometers.
Piezo electric type Accelerometer and damped mass and spring assembly Accelerometers are most commonly used.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
field bus transmitter calibration procedure tell me
What is the purpose of bypass valve across AS valve.
what is span value and zero ? and how set ?
diff between neutral ,ground,phase , earthing and shielding?
how to calculate the total flow in square root
which type of zones used for boiler? & why ?
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
What is instrumentation instrumentation engineering?
what is cems analyzer explain with principle and drawing ?
What is the procedure of calibration of Load cell?
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
what is basic difference between motion balance and force balance in pneumatic instrument?
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
