Interested to Buy Any Domain ? << Click Here >> for more details...
what is unit and element of viberation?
- 1 Answers
- 3224 Views
- Kentz, KOC, I also Faced
- E-Mail Answers
Answer Posted / faiyaz
Micron
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Explain PID controller tuning & any one method used for it.
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
How ejector(or)evactor air pump is working in thermal power plant?
There are many type of control cable like pair,core,tried, What are defination each one
What is instrumentation measurement?
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
defination of radial vibration?
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
what is sil (safety integrity level
while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
