Interested to Buy Any Domain ? << Click Here >> for more details...
basic priniciple of induction motor
- 2 Answers
- 4713 Views
- Electronics, Ramco, I also Faced
- E-Mail Answers
Answer Posted / ranjith
Induction motor works on the principles of Faraday's law of electromagnetic induction
Current is produced in a conductor by moving it in a magnetic field..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
can we conduct the swineburne's test on a dc series motor? why?
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
please send 5yearje solved papers on my email himmatsinghnathawat@gmail.com
difference between high and low impedance BUS BAR relay??
Difference between rating factor of cable and derating factor of cable?
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
How To increase Knowledge Of boliler regarding To Only Electrical Field..
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
how are reversing the direction of dc motor
sir iam a 3rd yr eee student.no core company comes for recruitment to our college.my aim is to be placed in l and t.tell me the procedures.
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
is it possible to have dc motors on single chip
