Interested to Buy Any Domain ? << Click Here >> for more details...
how can we detect that which is receiving side and which is
sendind end of a trnasmmison line by just seiing it?i.e its
which end is coming from genertaing and distribution side?
- 5 Answers
- 6849 Views
- I also Faced
- E-Mail Answers
Answer Posted / goutam roy
We can't see the flow of electric current and also the electric pressure so without marking the direction of G.S.&S.S How can you tell that , where is the source point& where is the load point, only with seeing?
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
Saving in copper achieved by converting a 2 winding transformer in to an auto transformer is determined by A voltage transformation ratio B load on secondary C quality of core material D size of transformer core
What are all present producing cost of Per KWH of various Fuel?
Why is a plain induction motor unsuitable for wide speed control?
HOW WE CAN REDUCE THE CIRCUIT COMPLEX OF STAR-DELTA STARTER .BECAUSE NOW WE USING ONE TIMER RELAY & THREE CONTACTOR FOR MAIN,STAR & DELTA ?IF ANY IDEAS PLZ POST.THANK U
Why does inductive loads consume KVARs?
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
What is the difference between a fuse and a breaker?
What do you mean by per capita requirement of electrical energy in india
List few applications of d.c series motor?
how to electrically make connection to ferroli GN2N?
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
What does the kvar means?
State superposition theorem?
