What is the function of an Auto reclosure relay. How does it
work??
- 4 Answers
- 16597 Views
- KSEB, I also Faced
- E-Mail Answers
Answer Posted / satyendra8714
If single phase fault (any one particular phase to ground fault) exist in the transmission line AR will operate. But single phase fault should be in zone-1 of the protected line. Then only AR will perform. If fault is in transient in nature then particular line breaker will open and wait for dead time after that breaker will reclaim if fault is cleared then no problem other wise differential relay will initiate three pole trip. This AR is mainly to minimize the outages.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are the limitations of Kirchoff's laws?
how to determine the cable size...pls explain me with the formula taking particular load....does the factors like impedance & short circuit rating influence the cable size, if so how....
What is the previous name of Cox's Bazar
Explain difference between stand by earth fault and residual earth fault protection?
hi frds, i m electrical engineer.can i get cdr for electrical engineer if u have then send me on my mail id its jayesh_ee88@yahoo.com.please help me frds
How to design the NGR Resistance
Discuss about gear cutting machines.
Is electro plating what type of load whether resistive, inductive or capacitive loads
for what purpose the star point is done in ct
Why is better to have a minimum ceiling voltage of 250% than 160%?
i need some project topics along with circuit diagram in the electrical adnd electronics engg and also give ome website regarding projects.my mail id is thenmozhi2k7@gmail.com .please help me.
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
Why we use circular(Stepped) cross section in transformer core?
how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.
Why we are use dol starter up to 10 hp
