Answer Posted / aditya199307@gmail.com

CT 200/5 ratio means if 200 amps flow in primary winding then it will be show 5 amp in secondary winding according to this phenomena it will multiply the given factor and show the current on the meter display.
But if we talking about its multiplying factor then it will depend upon its meteric unit like Mwh/Kwh.
If it will be on Mwh then MF is 1
If it will be on Kwh then MF is 1000

As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.

1841

---

What happens when two positively charged material is placed together?

1132

---

Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?

1953

---

how line turns ratio changes in 3 phase with change in connection

1974

---

What is principle of Floroscent tube 36watt.

2037

---

working function importance of mdc meter

2157

---

In a single how much maximum current and watts using

2153

---

What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?

1897

---

hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.

1911

---

for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.

2571

---

explain transformer ct connection?

2050

---

For overhead protection we use which transformer?

2479

---

Thumb rule of cable size(rm>30 rm)X multiplying factor=ampere

1605

---

how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?

2601

---

what is the Earth Voltages in Power Plants, Sub-stations, Industries, Residential & Commercial Buildings.

2099

---