Interested to Buy Any Domain ? << Click Here >> for more details...
200-100/1-1A – Transformer Knee point voltage
- 1 Answers
- 3018 Views
- AAPT, I also Faced
- E-Mail Answers
Answer Posted / ajai.m.k
testing voltage applied across scondary terminal magnetizating current will increase proportion to a applied voltage untill the knee point reached
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
what is the principle of operation of CFL ??
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
How you calculate the repturing capacity of a HRC fuse
What type interview questions ask in Electrical technicians
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
State the points to be considered for selecting a particular type wiring.
What is the reason that the humming sound is coming from the induction furnace panel?
How to calculate VCB rating for 33KV ,25 MW Power line?
what is PID control in VFD drives?
what is per unit calculation?looking for simple and strong explanation thk u
I want to calculate how much capacitor we connect to maintain the unity power factor? Is there any formula? Pls give me the answer
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
The SFC of an engine is 0.25 kg/kW hr. when the fuel used has a calorific value of 36000 kJ/kg. the thermal efficiency of the engine is
