Answer Posted / narendraton
V=ir
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Any one can explaination about calibration with rotating sub standards?
What are root loci?
define reflection method?
What will happen if the voltage in my house drops from 220V to any lower voltage?
What are the factors which influence the choice of specific magnetic and electric loadings of a synchronous machine?
what is JE exam?
What are test signals and their significance?
A 1F capacitor is charged to 100V initially. A 1H inductor is connected accros the capacitor througha a switch. The current in the circiut when the switch is closed is____
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
what is PID control in VFD drives?
How can we find out LT UG cable fault (size,from-4*25mm sqr to 4*300mm sqr)? How mani types UG cable faults?
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
What is resonant peak?
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
Explain Continuous and Discrete signals?