Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between LT and HT power supply?
- 26 Answers
- 187493 Views
- Center One Mall, Central University, JSW, Siemens, Suzlon, I also Faced
- E-Mail Answers
Answer Posted / mukesh
Lt means low tension voltage which is requires for domestic use
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is mean by Digital Logic Meter (DLM)
Why sometime AVR and sometime Booster coil is used in Alternator? what is the diferance between AVR & Booster coil due to which they are selected
How to calculate the sag on transmission Lines.
How to test Alternator stability test for REF relay
Where voltage are high and current to be interrupted is low the breaker preferred is:
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
Why we find the sensitivity for the CT's to check?
can u please mail me the syllabus for GET exam for damodar valley corporation?
Hi, This is Laila. I am selected for syndicate bank interview. Could you please share your views and the questions asked if you have faced the interview My email id is laila_honey09@yahoo.com Please send as fast as u can.Thank You Thanks... Laila.
how does high earth to neutral voltage affect electronic equipment?
How to design harmonic filter at the project stage without nowing the harmonics levels
can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...
what reason of line current and phase current in star connection and line current and phase current not equal in delta connection?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?
