Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / harish
Because of its triggering we use Scr In plant.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
sir please send me techinical questions for junior engineer posting in bangalore railway i am diploma holder
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
What is pi controller?
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
Why temperature rise is conducted in bus bars and isolators?
Draw the line diagram of diffretial relay connected to transformer?
How to select circuit breakers rating eg. if i select a circuit breakers of capacity 40 amps DC with operating voltage 28 volts and if i what to use same circuit breakers for 300 Volts DC application what is the current rating of this circuit breakers.
What are the factor to be consider for CT selection in 132kV substation?
how you configure motorvision relay (L&T make)from DCS
I want to know the 'Test voltage' for Tandelta testing of 3.3 / 6.6 / 11 KV Motors. Please explain
explain the what is a drive ? 0 4 which type motor r use in the celling fan..... PCB plannet 2 13 If stator & rotor of a 3-phase induction motor have different no. of poles, will the motor run or not?? types of drives Why dc supply is used for closing and tripping coil of ht breakers. What happen if we use only ups ac supply only. ACC 1 41 how the 3phase induction motor is running in 2phase supply with help of capacitor? 1 33 what is the actual difference betwen constructional details and constructional features? 1 20 how does commutator convert a.c to d.c?
What is center gravity load in substation?
explain with diagram how to protect transformers and substations from over current with help of CT's?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
how to calculate percentage impedence at 75 deg C at normal tap
