Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sunil
If +ve & -ve comes means DC , so T/C output is DC mV
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the reset offset and control system in instrumentation
flow transmitter formula?
What is stripper & spilitter ? Diffrence in this.?
what is sliding spool valves?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
what is cold loop? difference between hot and cold loop?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
typical loop drawing of a simple feedback control comprising of one transmitter and one control
How to convert milliampares into flow??
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
Why are the uses 24vdc in industries
how to work static pressure sensore how to work dpt
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
How to calibration coriolis flow meter?
