Natural frequency in the control system represents nature of
a. Transient response
b. Oscillations
c. Overshoot
d. Speed of responce
Answer Posted / bb
oscillations
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What is expention fastener (Fan)
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
what is the pulse and audio frequency transformer? what is different between induction regulators and tap changing transformer?
i applied for the ap transco please forward the freqventley asked QA
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
What is deference between MCB & MCCB & ISOLATOR
Why slip ring ind. motor power consumption is low compare to induction motor .same 90 kw motor used same load output
What is cathode ray oscilloscope (cro)?
what is resver in electrical enginnering with answer
how the characterstics of control valve being done
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
why in the three pin plug all 3 pins are cutted ?
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.