Why attemperation is required in HRSG in a combined cycle
power plant?
- 10 Answers
- 22747 Views
- Tata Power, I also Faced
- E-Mail Answers
Answer Posted / sunil
In CCPP secondary superheater coils are located near to flue gases and exhaust of gas turbine enters boiler . Exhaust of GT are at high temp around 600C
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Looking for Bently Nevada surplus 3300/52-01-00-00 Reverse Rotation Monitor , 4 pieces.
what is the basic use of power plant in equipment
We have Demin Closed cooling water system with expansion tank for cooling oil system. Expansion tank having N2 bladder. Whenever N2 bladder bursts out, Closed cooling water circuit pressure drops and make-up happening, eventhough there is no leaks. And how Circuit pressure drops?
By any way can we increase the B check hours from 300 to 500
How We Calibrate the vaccum transmitter?
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
what is natural frequency of turbine shaft .
LAPT working in alternator / generator
Which will have more strain energy 1.Spring 2.Circular disc 3.Solid square plate.
why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.
procedure of how to generate power in solar plant.
can u please tell me how to calculate the concrete quantity for a under reamed pile? r=300mm,depth=3m for a cylinder and for bulb l=.750mm,width=.525
