Interested to Buy Any Domain ? << Click Here >> for more details...
what is use single seated and double seated valve?
- 2 Answers
- 4718 Views
- Doha Petroleum Construction DOPET, I also Faced
- E-Mail Answers
Answer Posted / praveen kumar
double seated valve-this type of valve used in high pressure line to minimze the force applied to the stem by process fluid pressure across the fluid.
Explanatioin:-there will be two opposed force vector, one generated at upper plug and another generated at lower plug. the plug areas are approximately equal, then the force will likewise be approximately equal and therefore nearly cancel. this make for a control valve that is easiler to actuate.
singlw seated valve used to low pre applications to control accurately
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why flow/pressure transmitter before control valve?
Programmable Logic control.
How to calculate mmwc values into tonnes?
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
What is standard procedure of manual mapping in Radar type level transmitter?
How to Calibrate Vortex Flow transmitter in field
why we take %i0.0 as input for twido plc
In apron feeder how TPH is calculated?
How to Calibrate Flammable gas detector in field
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
please send the drdo exam paper
