why the frequency in india is 50 50HZ why we not select the
o ther frequncy range?
- 6 Answers
- 8136 Views
- I also Faced
- E-Mail Answers
Answer Posted / jamshid al rahman
As per my view,
Our Ancestors used and followed so most of the equipment's are designed for 50Hz if we change it we may need to change most of the equipment's currently using.
There are many advantages for different frequencies also disadvantages too.
as replay for one of the above comment, for transmitting it is better to use DC which has no frequency. So lower the losses and utilizes the entire conductor unlike AC flow on surface and inner area is useless (skin effect).
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Where is servomechanism used?
neutral earth resistance testing is it possible for transformer while in load condition
What types of high speed CMOS circuits have you designed?
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
Define what is difference between fuse and breaker?
What are your future plans for the company if permanently employed?
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
Differentiate between low pass, high pass and band pass filter?
How npn and pnp transistor works
can we install HT panel & LT panel side by side or how much clearance is required ?
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
In radial network the source is fed from 1 end both ends at central
What is signal flow graph?
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
What is Scheme Test of High Voltage Switchgear. Which tests it includes.
