Interested to Buy Any Domain ? << Click Here >> for more details...
why we not use capcitor in Three phase motor ??
- 2 Answers
- 3313 Views
- GOMS, Power Electronics, I also Faced
- E-Mail Answers
Answer Posted / dev123kk
we can use it for improvement of pf but normally dont use bcoz it has rotational field and descent power factor.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Dry type transformers
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
how to calculate vfd o/p voltage by frequency
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
What is the difference between isolators and electrical circuit breakers? What is bus-bar?
why we use 630mm single core cable for transformer secondary side and why two neutral cable
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage
What are gain margin and phase margin?
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
Please tell me in DETAIL about the following 3 types of fuses or recommend me a good power system protection book or a website link ? 1.Dropout Fuse 2.Striker Fuse 3.Empulsive fuse (not sure if its impulsive or explosion fuse , sorry)
how rectifier transformer work in electroststic precipetatore(esp?
I am B.E.electrical engineer having 7 years of experience in Transformer testing upto 315 MVA.I want to khow how I can get the 'Electrical Valuer' License.
What are the three constants associated with a steady state error?
