how we calculate capacitor bank mvar for 11 kv distribution
networ , and i need releation between capacitor bank with
voltage, frequency, current, pf
Answer Posted / basith
Mr.hajmyd,
if you use schneider make capacitor.all details are availabele in schneider catalogue.
just search in schneider website page.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the formula of frequency ?
Which type of DG need Netral Earthing?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
how much excitation voltage required to generate 1mw power?
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
Why frame of the motor is specified?. If we mention KW and voltage level,automatically frame is decided or separately frame is compulsory to mention?.
What is voltage divider rule?
How to check the LM324 Ic
11000volt DG set carnt kaise banvay
what is excitation/
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
When lag/lead/lag-lead compensation is employed?
why we use circuit breakers for switching instead of normal switching device?