Interested to Buy Any Domain ? << Click Here >> for more details...
what is the main difference between simplex RTD and Duplex RTD?
- 6 Answers
- 79538 Views
- I also Faced
- E-Mail Answers
Answer Posted / bhopal
Winding RTDs are embedded between coils inside a CRNGOSS (cold rolled non grain oriented silicon sheet steel) core slot. It is nearly impossible to replace a damaged/erroneous RTD, since the wound stator capsules are rasin dipped/VPIed(vacuum pressure impregnated). Taking out the top coil to insert fresh RTD will surely damage the insulation. A duplex will offer an additional source for measurement.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
Write the analogous electrical elements in force current analogy for the elements of mechanical translational system.
what kind of technical test that i need to learn because i have an interview tomorrow.. please someone help me..
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
i am gng to visa interview this july i have 4 backlogs gre 1010,toefl 75,pls give me the tips pls pls
what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
What we mean by vintage of an engine+Generator?
What is resistance of 50meters, 16sq.mm, single core copper cable?
why is using sensor?what is differece between photoelectric and proxmitty?
sir i applied for hpcl(electrical).i want to know from which subjects most of the technical que will b asked.and pattern of the written test.pls help me
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
show the single line diagram of star delta starter with single phase preventer
