Interested to Buy Any Domain ? << Click Here >> for more details...
What is the differance between Digital Energy meter &
Static energy meter? why the KWH diferance between both
meters.
- 3 Answers
- 22103 Views
- Raychem RPG, I also Faced
- E-Mail Answers
Answer Posted / unmesh
Static and Digital Energy meters are same.Electronic Energy Meter is based on Digital Micro Technology (DMT) and uses no moving parts. So the EEM is known as “Static Energy Meter” In EEM the accurate functioning is controlled by a specially designed IC called ASIC (Application Specified Integrated Circuit). ASIC is constructed only
for specific applications using Embedded System Technology. Similar ASIC
are now used in Washing Machines, Air Conditioners, Automobiles, Digital
Camera etc
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
how many types control panel of a 132/33 kv substation
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
Define what is difference between fuse and breaker?
What is servo motor and what are different types of servo motor
How much costly in percentage wise is sandwich busduct costly than air insulated busduct of any rating?
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
How to calculate or formula to calculate rhe power in 2 phase system ??
explain the types of drives
what is the safety points of vaccum circuit breaker.
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
explain different losses in a transformer.
If not into production, how far did you follow the design and why did not you see it into production?
How does the phase sequence controller works, how it identifies the phases? confirm working principle
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
