Interested to Buy Any Domain ? << Click Here >> for more details...
what is rotating transformer? what is the uses of it?i mean
applicaitons?
- 5 Answers
- 29392 Views
- First Lead, I also Faced
- E-Mail Answers
Answer Posted / sam
Rotating Transformer is a device to transfer electrical energy AC from stator to Rotor in AC and opposite/reverse.
Basically, it send AC supply to rotor by AC supply from sec. So its not use brush/slip ring. This rotating transformer is used for synchronous motor mostly. More question u may contact me WA +97433450404
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
can the measured percentage error during calibration of single phase energy meter be negative?
Dear Sir I am living in Jaipur Rajasthan now I did complete my b tech degree in electrical engineering in 2012 Sir how I gate certificate of competency for electrical supervisor
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
i am studying in final year can i allowed for 23rd UES of Indian army
how to failure indution motor insulation & how to improve heat in motor insulation
How can get elongation of 2 k.G aluminium, if elongated aluminium dia is 2.5 mm?
what work will do diffrential realay DG set
what is the minimum winding resistance of 30hp compressor, to run or to switch on
Why neutral is not used in three phases dol starter
how to read idmt curva
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
what about GD square and its important for motor design?
the problem faced on star or delta winding connection??
Define the term factor of inertia.
How to decide cable tray size?
