Interested to Buy Any Domain ? << Click Here >> for more details...
What is difference between ON delay and OFF Delay Timer?
- 7 Answers
- 53474 Views
- I also Faced
- E-Mail Answers
Answer Posted / dgfdhgfg
On-delay timers
With an on-delay timer, timing begins when voltage is applied. When the time has expired, the contacts close
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
How DC earth leakage currents can be reduced ?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Give two basic speed control scheme of dc shunt motor?
STATE USE OF ARC RUNNERS & SPLITTERS ?
when 20hp 3 phase motor start no load condition in star or delta connection.find current and write formula.(tariq)
A 400KVA transformer has 400 Hz frequency. If the frequency is changed to 50 Hz, then what will be the new KVA rating?
WITCH CARDS IN USE IN FIRE CONTROL PANEL.
The sodium vapor lamp is not glows when it is connected a distance of 5 meters above from gearbox, why ?
Why delta star trformers are used for lighting loads?
for 750 kw LT load what will be the ht kva
how we will deside the high voltage value
what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?
Show Details FROM:Muhammed Ikram TO:qa@allinterview.com Message flagged Saturday, June 4, 2011 10:07 PMMessage bodyHello all, i want to ask a question to all of you that what is VMM (voltage monitoring module )? how it work,s? i heard somewhere that it compare 1 phase voltage to other phase voltage. but there is also some setting on it. how to set it,s setting. please tell me briefly. Thank,s and Regard,s. Muhammed Ikram.
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
can we install HT panel & LT panel side by side or how much clearance is required ?
