Ohm’s law, kirchoff’s law, pascal’s law, Bernoulli’s therem,
Answer Posted / faiyaz ahmad
Ohms law states that when current is flowing through the any conductor then current is directly proportional to the voltage universally proportional the resistance if temperature is constant.
Bernoulli theoram state that total energy flowing from the one point to another point remains constant its generally used in non compressible liquids.
Charles law if the pressure and the amount of gas remain constant the volume of the gas increase or decrease by the same factor as its temperature.
Pascal law pressure change occurring any where in the fluids.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Yokogawa CENTUMVP R6.09 unable to download to Engineering Station with ExaOPC R3.75
The issue is when I try to download the common project section to the Engineering Station (STN) from the HIS in System View, it is unable to connect. The error displayed is:
WARNING: Could not connect to equalize destination. (7001)
Retrying. Number of retries = 0/1
ERROR: LdXopsLoadMain: connect error 10060
ERROR: Processing terminated due to connection error. (7002)
Equalization end with errors. STN0149
---- ERROR = 2 WARNING = 1 ----
Background:
>Updated the ExaOPC software on the STN from 3.60 to 3.75
>STN operating system is Windows Server 2008 R2
>HIS operating system is Windows Server 2016 Stanard
Solutions attempted include:
>Ensuring all IP addresses are correct and all networked devices can be pinged.
>The ability to ping a device using its host name from another device (
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
what is cems analyzer explain with principle and drawing ?
how to commission furnace ( water heater)
what is performance test.need defination
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
How an rtd work, and what volts/current goes to a rtd to measure the resistance?
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
what is the calibration procedure for transweigh make weigh feeder?
why Fahrenheit unit of moistur analyzer transmitter
what is output of FOUNDATION FIELD BUS transmitter
What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?