What are the questions asked in PRDC pool campus test?(bangalore)
Answer Posted / manukl
I have taken PRDC pool campus interview in my college. Paper had 100 questions to be answered in 100 minutes. each carrying one mark each. Also paper has 3 division programming,Technical and aptitude. In programming thorough with c,c++. For aptitude prepare only important topics from r s agarwal. In the technical below questions were asked.
1.Type of test on isolator ?
2. Ideal DC generator has __ regulation.
3. Switching sequence of isolator, CB and earth switch.
4. What type of design does rotor of synchronous generator has?
5. Ybus matrix is a __ matrix?
6. Where does the condition happen 3 phase fault> 1 phase? (In power system)
7.Given f=500Hz, l=500km in which TL model do u model it?
8. Bucholz realy?
9. Synchronous motor usually have p.f of ?
10. Material used to control the chain reaction in nuclear reaction?
11.If voltage controlled bus is treated as load bus, which limit will be violated?
12.Tidal energy make use of?
13.Solar cell made of?
14. With same maximum voltage to earth, Which AC system (p.f 0.8) will require more copper as compared to DC 2 wire system?
15.Differential Protection employed for?
16. In DC generator Eg proportional to?
17.H=2 for 400MVA then H=? for 800MVA?
18.3 phase 4 wire system has RYB phase sequence with R=230(arg 0) then Y=__
19.DC series motor has rated speed, voltage feeding a constant power load if speed has to be reduced to 0.25 pu. supply voltage has to be reduced to?
20. Normally Zbus matrix is __?
21. In alternator relay protection necessary against against ?
22.Shunt capacitor are connected at a bus in order to__?
23.Inductance realted to length as ?
24.Flux of transformer related to frequency as?
25.Critical resistance of DC generator is the resistance of __?
26.Air filter used in which filter__?
27.On occurrence of unsymmetrical fault, the sequence component which is always greater than negative sequence component is??
ALL THE BEST!!!-----------------Kolpe-------------------------
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
For some transformers we are using solid neutral earthing while some others we are using resistance earthing why ?
How time response of the system is divided?
what is the difference between electrical choke and electronic choke?
What is the purpose of stand by earth fault protection for transformer ?
why in the three pin plug all 3 pins are cutted ?
I want to calculate how much capacitor we connect to maintain the unity power factor? Is there any formula? Pls give me the answer
what is the transformer rush current?
explain single phase series motor
What is mason's gain formula?
What is touch potential and step potential?
What is reactive power and where it is used.
what are the major & minor faults that occur in an inverter and in UPS ? And how to repair and resolve them ?
how do u gauge the size of the cable ?for eg. consider a 300 sqmm L.T Cable.How do u determine the size of the cable seeing it pratically?
Operation of isolators.
what are safety measures in /control in diesal engine/ explain them?