Interested to Buy Any Domain ? << Click Here >> for more details...
what is the meaning of potential free contact.
difference between dry and wet contact?
- 6 Answers
- 95768 Views
- GAIL, I also Faced
- E-Mail Answers
Answer Posted / naushad ali
A contact not used by owner is a potential free contact to the user.Think about a MCC and an Instrument panel.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
diff between neutral ,ground,phase , earthing and shielding?
Isometric drawings are generated during _________________ phase of a project
Calibration procedure for Electro magnetic Flow meter
How to Calibrate Level Troll in field
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
How to calibrate level transmitter with use of HART?
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
Explain PID controller tuning & any one method used for it.
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
How to Calibrate Radar Level Transmitter in Field
