Interested to Buy Any Domain ? << Click Here >> for more details...
what is the main difference between simplex RTD and Duplex RTD?
- 6 Answers
- 79539 Views
- I also Faced
- E-Mail Answers
Answer Posted / g. sahu
Simplex- Single sensor in a RTD/ TC.
Duplex- Double sensors in a RTD/ TC.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
Earth leakage relay basic knowledge principle
Can RCD's used to protect the VVVF drive if not why.
what is meant by motor startup supervision & motor load jam protection ?
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
Write down the brushes of a de machine.
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
What are motor generator sets and explain the different ways the motor generator set can be used ?
how to calculate the earth fault current
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?
where are the circulat the diesel in DG parts name with pictue
Can we use shunt trip coil instead of trip coil with protection relay for protection?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
3ph motor running with unequal kw and different pf what are the reasons
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
