Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / faiyaz ahmad
14.7 pounds per square inch
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
Define cryogenic?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
what are the steps I have to deal with?
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
what is thermo coupler and how it works
What is frequency factor in massflow meter? When using frequency output?
How to Calibrate Ultrasonic flow Transmitter in Field
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
how to work static pressure sensore how to work dpt
What is profibus?
How will you test a transistor with a multimeter?
what is a half wave, full wave, and bridge rectifer.
what is wave length were using ?
