Interested to Buy Any Domain ? << Click Here >> for more details...
the square root type transmitter r used to which applications
- 4 Answers
- 7246 Views
- Roche, I also Faced
- E-Mail Answers
Answer Posted / faiyaz ahmad
For flow measurement
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Explain PID controller tuning & any one method used for it.
Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
why we are using magnet for calibration of gas detector?
what is IEC code in cables & how to selecting cables?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
Question on maha cement
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
full process of gas turbin?
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
