Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kamath
lap length is the enough length to be provided so that the bond between steel and concrete remains strong.usually it is provided 30D in tension and 24D in compression.but to avoid confusion between the bar benders and contractors and to be on safer side we provide 50D both in compression and tension.where D is diameter of rebar.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How much does the leaning tower of pisa lean?
For submitting the project loan for bank Residential bldg,Suppose we take Provinding RCC mix 1:2:4 for footings No of footings,length ,Breadth,Height ,qty in cum, at last unit/Rate(Rs) ,i would like to know how do we get the unit/Rate
What will you do if a portion of load bearing wall collapses under your supervision?
16 questions out of 55 were from the book GUPTA N GUPTA OBJECTIVE of civil engineering. Total ques were 4 ques from hydraullics, 7 from BMC, 4 FROM SOM, 4 from soil mechanics, 6 from transportation, 5 from engineering drawing.
what is relation between SPT N value and driving piles after conducting a soil test?
for pretensioning which will yield first and same for post tensioning?
give me the mix proportion for design mix concrete M 7.5 grade 1:4:8
What is the diameter of the 3"inch nails?
Define What are the reasons for geotechnical site investigations in Uganda?
How do we test on design and style in a software?
How is the strength of cement measured?
What are the uses of layer?
What is the l/d ratio of cantilever beam?
how to preaper for interview wat they asked in interview give me idea
How to use of me trial wall plaster 6mm , 10mm par sqm. use in sand and cement ?
