Answer Posted / ankitshah55

Because rain drops are not continuous. Only in rare cases if rain is full than not only LL but LLL fault can also occur. But in transmission lines the design and slag plays the important role. Also insulators are designed so that water cannot accumulate.

WHAT IS DEAD END IN PROTECTION?

2593

---

what is basic difference betmeen normal & flame proof motor??

2030

---

What will happen if the voltage in my house drops from 220V to any lower voltage?

2203

---

How to maintain ac plant?

1954

---

Can anyone tell the proper diagram of star delta starter????

1930

---

What are the conditions to be satisfied for parallel operation of dc generators?

1098

---

What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?

4035

---

What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?

2254

---

Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?

2123

---

In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]

1982

---

How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.

2796

---

Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.

2034

---

How we can come to know the substation range,without go through any name plate ?

2108

---

Explain Circuit Breaker Trip Characteristics in detail.

2136

---

sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"

2060

---