Interested to Buy Any Domain ? << Click Here >> for more details...
what is relation between vector group of transformer and
its load hormonics?
- 1 Answers
- 4624 Views
- Sanmar, I also Faced
- E-Mail Answers
Answer Posted / gowtham g
vector group of transformer-Three phase transformer consists of three sets of primary windings, one for each phase, and three sets of secondary windings wound on the same iron core.load hormonics-Harmonic voltages and currents in an electric power system are a result of non-linear electric loads. Harmonic frequencies in the power grid are a frequent cause of power quality problems. Harmonics in power systems result in increased heating in the equipment and conductors, misfiring in variable speed drives, and torque pulsations in motors. Reduction of harmonics is considered desirable.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Can anyone explain me about the capacitor calculation
how to test the electrical panel.ht lt mcc pcc.
Name the types of motors used in vacuum cleaners, phonographic appliances, vending machines,refrigerators, rolling mills, lathes, power factor improvement and cranes.
how to decide the panel size like MDB ,SMDB PANEL SIZES
How to Prepare preventive maintenance shedule of machine tool.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
tell me about eletrical contractor
What's mean HVF & HAF in Vacuum Circuit Breaker?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
Hoe do calculate the Cable size for Amps rating ?
Is a 300w induction motor used in a food processor as powerful as a 1000w DC motor.
What is servo motor and what are the applications of servo motor?
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
