Interested to Buy Any Domain ? << Click Here >> for more details...
I am applied 100 % pressure on to the air to open control valve,but the valve is not fully closed..and 10-15% is open the valve. how to calibrate the control valve?
- 3 Answers
- 4307 Views
- OPaL, I also Faced
- E-Mail Answers
Answer Posted / subhendu paul
Ur questions is not clear. For open the valve is clear BT how or which pressure required or used to closed. Plzz sir. Clear the my confusion
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is zener diode? What is voltage regulator?
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
Explain the combusion chamber
what is the reason while warning lamp is on while the engine is cranking?
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
What are the maximum packet size of: a) HART b) Profibus DP c)Profibus PA d) DeviceNet e) Foundation Fieldbus
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
how to convert cubic metre per hour to newton cubic metre per hour
what is the reset offset and control system in instrumentation
what is droop in governer ,type of droop ,how it work
