Interested to Buy Any Domain ? << Click Here >> for more details...
difference between a four point starter and three point
starter
- 9 Answers
- 79010 Views
- I also Faced
- E-Mail Answers
Answer Posted / sandeep
In case of any three pointstarter NVC is connected to the shunt field winding so if voltage is fall certain value the no volt release coil de magnetise so motor will be off. But in case of four point starter the no volt release coil is directly connected to the supply so the NVC no way the demagnetized.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
difference between servo motor and synchronous motor
best manufacturer for busbar for outdoor switchyard having double bus bar scheme, can any one share technical specification of busbar. 132kv voltage ?
How to find ampere on ht side for selection of cable size ???
What is the Diff. btw Manule Pull Station & Manule Abort Station Switches used in FM200 System??
hwat type of motor is used in thermal gas turbine hydro nuclear power plants and why
Why is tan-delta test and capacitor measurement done on alternator?
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
sir, I am from EEE branch.On feb 17 iam going to write an Exam for hindustan petrolium corporation Ltd.So plz send me the written exam pattern/Q's/interview questions.please mail to eee_dharmendra@yahoo.com
why need to be maintain power factor for industrial customer?
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
What is deference between MCB & MCCB & ISOLATOR
how to find out cable size if load is 2800 watts, 230 volts AC supply and load distance is 1800 meters
What are high pass filter and low pass filter? and What are the flowmeter ?
