Interested to Buy Any Domain ? << Click Here >> for more details...
What is RTCC panel and why it is required
- 31 Answers
- 133899 Views
- RTCC, Tivoli Grand, I also Faced
- E-Mail Answers
Answer Posted / basir
RTCC means- Remote tap changing controller
And it is used to maintain the stable output voltage of the transformer by
changing the taps because we need constant voltage.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how to calculate the settings for shaft ct protn in hydro generators
how flow current in 220 kv line to line
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
How grounding is different than earthings?
what is earth fault relay 64T, why it is used in main Incomer and neutral CT of Transformer.
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.
If short circuit ratio is high is it bad or good for a machine then tell the reason...
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
Define settling time.
What do you understand by oldham's coupling ?
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??
how 650 volts creates? where is use?
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
State angle criterion.
