Interested to Buy Any Domain ? << Click Here >> for more details...
What is basic impulse insulation level? And how it is calculated for sub-
station?
- 2 Answers
- 11955 Views
- I also Faced
- E-Mail Answers
Answer Posted / madivalanagaraja@gmail.co
The Basic Impulse Insulation Levels refers to the ability of electric equipment such as transformers to withstand lightning surges. When lightning strikes a transmission line, a traveling wave is created. This traveling wave travels along the line and damages the transformer winding.
Surge arresters mounted on the line can mitigate the surge, however, they cannot totally eliminate it. Voltage surges can also be created by the switching of circuit breakers and switches.
The BIL or the Basic Impulse Insulation level indicates the ability of the transformer to withstand these heavy surges. Transformers with a rating of 600 volts and below are designed to have a BIL of 10 kV.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the series parallel connection of capacitors? and how can we use these application in three phase motors for controlling torque?
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
What are books to be referred for KPTCL exam?
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?
Explain and give examples about VCB?
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
What is the difference between single point and double point bonding. please kindly detail about bonding of cables.
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...
What is nichols chart?
1.4 What is meant by CT knee point voltage and how would you determine it
What happens if we connect a single phase energy meter in reverse polarity.
