Answer Posted / neel patel
I can use many electronic devices, they are connected in series , power supply constant with connection and without connection both connection power will constant following. Thats known as the uninterrupted power supply (UPS).
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Can you explain about pole discrepancy scheme
What is difference between insulating medium and fault current interruption medium in a switching device.
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
HAI SENT HPCL APTITUDE QUESTION PAPER, MY EMAIL ID IS angus_eee04@rediffmail.com,angus_eee04@yahoo.com
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
what is the Pickup/drop off ratio in BCPU relays
How vfd saving power.
Briefing the effects of ASR and ACR of a double closed-loop speed regulating system.
How to find ampere on ht side for selection of cable size ???
How to measure size of cable on a given load
can some one clearly explain why -48 volt DC use in telecom site????
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
how to measure the transformer resistance values(dyn11)?and howmuch the minimum value?
briefly explain principle of resistance welding
Give idea about General Engineering. From which book i can study this topic. Pl. reply me via email. My email is ravi@bhelhwr.co.in, also give the name of book/website, from where i can prepare it.