Interested to Buy Any Domain ? << Click Here >> for more details...
where connected OLTC for transformers?
- 3 Answers
- 7493 Views
- Apollo, CBRE, I also Faced
- E-Mail Answers
Answer Posted / muthu
OLTC Should be connected on HV side...bcz where current will b low,hence loss,arcing vl be less while changing taps.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is the current setting for different relay protection for transformer .
how does an encoder work???
how to calculate the breaking capacity of different breakers.
Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?
What is a surge supressor why its is used in synchronous generators
The windings of a transformer are divided into several coils, because?
sir please send me techinical questions for junior engineer posting in bangalore railway i am diploma holder
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
Is the installation of the filter cloths necessary before spreading the gravels at the transformer yards?
1.what is the difference between ct and cvt? 2.what is the difference between pt and cvt? 3.what is the difference between relays and circuit breakers?
what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips
What are the three constants associated with a steady state error?
Hello everyone, somebody knows what is a "surplice power" ? The hole phrase is: "This rating is appropriate for a generator set paralleled with an infinite bus e.g. a national electrical supply network or grid where the generator set is run at 100% load, 24 hours a day, 365 days a year and any surplice power is exported into the grid" Thanks in advance.
how can i change the rotation of the AC single phase induction motor and show me by diagram
