Interested to Buy Any Domain ? << Click Here >> for more details...
why we connect digital multimeter in series for dc current
measurement and parallel for dc voltage measurement.
- 4 Answers
- 10773 Views
- I also Faced
- E-Mail Answers
Answer Posted / talha
In a D.C. circuit where there is a constant current flow, the digital multimeter is connected in series with circuit because the same current flows throughout the circuit from the positive side of the battery to the negative side and through the battery back to the positive side and so on.
The digital multimeter is connected in parallel to measure D.C. voltage because in parallel, although current varies / splits at parallel nodes, voltage remains constant.
Simply put in series connection, current remains constant and voltage divides. In parallel connection, voltage remains constant and current divides.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why plc require in analog input 4-20amp & 0-10 volt?
List three types Level Switches with their working principles
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
what is the difference between -24 : +24 & 0:24 and where it use?
What is the diffrence between digital signal processing and discrete signal processing?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
principle of automatic votage regulator
Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?
Coal mill Instruments Equipments for cement plant And process diagram ?
What is the difference bitween control net scaner and device net scaner
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
How to calculate P,I&D value in PID controller ?
wich is coming the first HAZOP OR SIL
How does your previous experience relate to the job you are applying for ?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
