Answer Posted / anil
It is the ratio of sum of the maximum demand of the system and to the total load connected. Demand factor is nearly less than one or an equal to one
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How will polarity test of Dy5 Transformer ?
In how we connect watt meter for open & short circuit test of a single phase transformer.
What are the main significances of root locus?
how to calculate vfd o/p voltage by frequency
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
if we have 320KVA Genset kindly advice how much load we can put it.
(1)Can earth and be conected together (2) what is the diferent between earth & neutral
Please give me a erda placement paper
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
what is the question paper model for section engineer in RRB
what is the control circuit for operating the clean room air shower
What are the causes for the failures of sandwich type (Al) busducts?
how to commissioning the genset with amf panel?
what are the parameters plays a major role in Potential transformer Burden calculation??
