Interested to Buy Any Domain ? << Click Here >> for more details...
What is difference between PLC and SCADA
- 13 Answers
- 70244 Views
- Uflex, Vimal Fire Controls, I also Faced
- E-Mail Answers
Answer Posted / dhanshri narayane
Plc is the individual computer control system that continuously monitors the state of input devices and make decisions based on custom process and monitors state of output devices.
SCADA is Supervisory Control And Data Acquisition is a system for remote monitoring and control that operates with coded signal over communication channels.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
When lag/lead/lag-lead compensation is employed?
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
is it value of power factor is more than unit. whats effects in the source supply
critically criticize the application of ring main unit in power system
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
Installation method of self treated earth electrode.
what is differnce btwen lll and lllg faults
how to get electrical supervisor competency certificate in gujarat. i did 3 year diploma in electrical
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
how we do Vector group ,magnetic balance and tap changer test in Transformer?
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
what is the function of gss in the dg set.
what is the function of bearing in dc mchine" and where it is placed
