Interested to Buy Any Domain ? << Click Here >> for more details...
CHEMICAL MATERIAL BALANCE - EXAMPLE 2.5 : In a non-dilute absorber, the inlet gas stream consists of 8 mol % carbon dioxide in nitrogen. By contact with room temperature water at atmospheric pressure, 65 % of the carbon dioxide from a gas stream has been removed. (a) Find the mole ratio of carbon dioxide and nitrogen gases at inlet and outlet gas streams. (b) The Henry's Law provides y = 1640 x for carbon dioxide in water. Find the mole ratio when x = 0.0000427. Mole ratio is y / (1 - y) for y.
- 1 Answers
- 2555 Views
- I also Faced
- E-Mail Answers
Answer Posted / kangchuentat
CHEMICAL MATERIAL BALANCE - ANSWER 2.5 : Basis = 100 mol / h. For inlet, mole % of carbon dioxide = 8 % and mole % of nitrogen = 100 - 8 = 92 % then mole ratio = 8 / 92 = 0.086957. For outlet, mole % of nitrogen = 92 %, mole % of carbon dioxide = 8 % (1 - 0.65) = 2.8 %, then mole ratio = 2.8 / 92 = 0.030435. (b) When x = 0.0000427, y = 1640 x = 1640 (0.0000427) = 0.070028, then mole ratio = y / (1 - y) = 0.0753. The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS +61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How does a tank-blanketing valve operate?
Explain what are some common precipitating agents used to remove metals from aqueous waste streams?
What are some good strategies for curing tube vibration in shell and tube exchangers?
Explain what are the design considerations for a piping system for the transfer of slurries?
Are there any special considerations to be taken into account for combusting ammonia?
Explain what are some good uses of low-grade steam at 12 atm and 1920c?
Which type of pneumatic control valve is used mostly Either Air to Open r Air to close the value And guys I need reason for your reason
marketing procedure of iocl
What is a cstr and what are its basic assumptions?
Explain the reasons of removal of particles from effluent gas?
What do we use carburizing/nitriding chemicals for?
Explain the different ways in which solids can be blended?
I want previous year question paper of ONGC for chemical engg.
What are some common problems associated with bellow expansion joints?
Is there a quick rule-of-thumb to estimate a gas side heat-transfer rate inside the tubes of a shell and tube heat exchanger?
