in three phase it represented by R-Y-B.what is full form of
R-Y-B.
- 11 Answers
- 39315 Views
- Sun Pharma, TCS, I also Faced
- E-Mail Answers
Answer Posted / vaishnavi
R stands for Red,Y stands for Yellow and B stands for Blue in a three phase
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
How to decide and select the different earthing wire size for the different types of earthing
if i am in front of transmission line how to know that current direction without any equipment
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
what is the significance of cabability curve of alternator
what happen if drive input fail momentry at 48.5 HZ frequency?
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
what is transient stability analysis means?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
what will happen when the dc supply is given to the capacitor?
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
what will happen if the prime mover on the field excitation of the on-coming generator fails?Explain.
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
why induction motors are rated at 0.8 power factor.
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
