What is the rating of your capacitor bank at your company.
- 36 Answers
- 76049 Views
- Ajnara Group, Amara Raja, Amol Electricals, Apollo, ATC, Bhagiradha Chemicals & Industries, Bharat, CBRE, Cisco, Government, JLL, MEIL, Reliance, Sterling, TNEB Tamil Nadu Electricity Board, Torrent Pharma, Victory, I also Faced
- E-Mail Answers
Answer Posted / m.reda
cap.bank used for p.f correction to compensate reactive power supplied from utility to reduce losses in power through t.l so we use cap near load in parallel ....how to calc cap rated
Quncorrected=pxtanφ1
Qcorrected=P×tanφ2,
where P- real power. From this we find the required Qc:
Qc= Quncorrected-Qcorrected=P×(tanφ1- tanφ2)
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
Could the power factor on electrical system can affect the registration of the kwhr meter or the CT/PT?
How a band pass filter is constructed?
Saving in copper achieved by converting a 2 winding transformer in to an auto transformer is determined by A voltage transformation ratio B load on secondary C quality of core material D size of transformer core
what is earthing transformer? draw the winding dia.of earthing transformer.
does a DG set has low fault level as compared to that of a transformer.If yes then why.
Define demand factor?
what r PID controllers?why they r used?what is there purpose?plz Explain in detail
What happen in ups if phase reverse?
how we do Vector group ,magnetic balance and tap changer test in Transformer?
How will you justify IR value and Charging voltage of any motor,transformer and Cables.......???? . . . . . . . . Plz tell me any body Baljeet Singh, engineer_89@refiff.com
kindly send me 11KV MV motor differential protection procedure by primary injection method.
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
What are the advantages of vscf wind electrical system?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
