Answer Posted / mnb

these logics are mainly seen in f&g system where signals from 2 sensors out of 3(2 out of 3) reaches preset value the system should shutdown or should do the actions programmed.
this can be used with any transmitters. Its main aim is to avoid unwanted shutdown.

why using negative supply for bentley nevada vibration system ?

2205

---

any body please send me the old question papers of ongc test.

2153

---

what is the importance of CV in the control valves? how it is calculated?

2502

---

How to Calibrate Level Troll in field

1467

---

plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}

2373

---

Why ac supply load cell is used? Can we use the dc supply load cell?

1121

---

What is the use of temperature compensation?

2075

---

Draw a P& ID showing – orifice flange, plate, dp transmitter, isolation & bypass valves and tubing.

1987

---

PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear

2008

---

Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.

2299

---

sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.

2508

---

Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?

1218

---

how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?

3731

---

which type of filter gives the constant phase characteristics?

1964

---

Can anyone convert a 5/2 way or 3/2 way valve into an ISO valve?

992

---