Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between LLL and LLLG fault ?
- 1 Answers
- 5200 Views
- I also Faced
- E-Mail Answers
Answer Posted / porketg
both are same , then how the potential at fault point can be zero in case of LLL fault , when there is no ground present in LLL fault
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
What are root loci?
what is a bus riser in power system and why it is used
Plz tell me how we can find that particular company has vacancy or not
In ACS 1000 drive we are using 12 pulse converter,why don't use 3 pulse converter.
how do u gauge the size of the cable ?for eg. consider a 300 sqmm L.T Cable.How do u determine the size of the cable seeing it pratically?
what is the formula of starting current of 3phase and 1 phase motor???
how to calculate the cable current ratingand and how much of distance the rating will be ok will the distance is incresed what the action we take
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
What will be the current if the resistance total in a series circuit doubles?
What is ramp signal?
What is difference between safe PLC and normal PLC
